"Rotation
Molded Equipment For The New Millennium"
SINT PLAST CONTAINERS ARE
IMMEDIATELY AVAILABLE TO MILITARY SERVICES WHO DESIRE THE FINEST CONTAINER MADE!
SINT PLAST under Dometic S.a.r.l. is manufacturer of high quality Rotation
Molded (roto-molded) Equipment. The unique manufacturing process used by SINT PLAST
ensures that strength, and quality are not compromised. Rotation Molded Equipment is
manufactured to exact customer specification with built in superior thermal insulation
qualities.
Key Benefits
Durable Yet Aesthetically Pleasing
Lightweight
Superior Thermal Insulation Qualities
Economical
Dependable Under The Most Adverse Climatic Conditions
Special Characteristics
Lower Molding Costs in comparison to other plastic
processing procedures; more economic manufacturing process for specific
applications.
Optimization of the manufacturing costs are possible
through the simultaneous production of multiple parts.
The processing operation is also suitable for large
product sizes (up to 1000 L volume for the double walled containers and up 2300 mm
diameter).
Unlimited variety of molds.
A single manufacturing cycle includes all of the
processing sequences.
The polyethylene is chemically neutral, therefore very
well suited for use in the area of foods, and has temperature stability over a large range
(-40oC to +70oC). Numerous applications are
therefore possible.
MANUFACTURING STEPS FOR ROTATION
MOLDED PRODUCTS
The Simulation With CAD
The Simulation With CAD
enables the development of a technical solution that is adapted to the requirements of the
customer.
The Two-Piece-Mould
The Structure Of The-Two-Piece-mold allows production of single or double walled
roto-molded parts.
The Polyethylene Powder
Before The Interior Mold is secured, a measured amount of polyethylene powder is
poured into the bottom of the exterior mold.
Manufacturing Cycle Input
The Duration Of Each Manufacturing Cycle - preparation, heating and cooling - is
programmed in the computer.
Heat and Rotation
The Double Effect Of Heat And Rotation when going through the kiln ensures an
even distribution of the polyethylene between the two walls of the mold.
The Cooling Chamber
The rotation molded part acquires it's dimensional stability when passing
through the cooling chamber.
Removing The Product
After this phase, the product has sufficient hardness and stability, so that the
pattern can be drawn - total duration: approximately 1 hour.
PUR Compound Injection
The PUR compound injected between the walls of the container solidifies when
passing through the kiln tunnel, giving the final product it's thermal insulation
characteristics.
UNIQUE MANUFACTURING
BENEFITS
Click On The Button Below See What
Gives Our Rotation Molded Equipment It's Strength
A Wide Color Range Is Available That
Can Be Adapted To The Customer's Wishes
SINT PLAST PLANT IN HOSINGEN, LUXEMBOURG
By Dometic S.a.r.l.
Name
Title
Company
Address
E-mail
Phone
Fax
Privacy Policy: We respect you the
customer and your privacy! K.C. Trading Ltd. will NEVER release your phone
number or e-mail address to anyone unless you request it and authorize us in
writing.
"This site contains links
to other Internet sites. These links are not endorsements of any products or
services in such sites, and no information in such site has been endorsed or
approved by this site."
The Simulation With CAD
The Two-Piece-Mould
The Polyethylene Powder
Manufacturing Cycle Input
Heat and Rotation
The Cooling Chamber
Removing The Product
PUR Compound Injection
